12" aluminium reflector with safety guard and one metre of chain plus quality heat resistant Edison screw lamp holder. Lead is 1.5 metres long and fitted with 13 amp plus and dimmer control to reduce output and power consumption by 50% (Bulb not included)
This heat lamp is designed for use in domestic and industrial applications.
These instructions contain important safety information and should be read carefully before commencing installation and retained for reference. Installation and maintenance should only be carried out by a suitably qualified person in accordance with these instructions. This product should not be modified as any modification may render the product unsafe and will invalidate any safety and approval marks. No responsibility will be accepted for modified product or for any damge or injury caused as a result of modification.
To comply with legislation and regulations the following must be adhered to.
Leave disconnected from the supply until installation is completed.
Secure the chain provided to the hook on the top of the heatlamp. Then secure the other end of the chain to a suspension point, and adjust its length to make sure that the space between the bottom of the heatlamp and the animal is NOT LESS THAN 0.5m. This gap is essential for the welfare of the animal and the prevention of fire. Fix the cable to the chain so that the chain takes the weight of the heatlamp and the cable is not under strain. Do not tension the cable. Ensure that the cable is not accessible by the animal.
This heatlamp is pre wired with a 13A plug with 3A fuse and should only be connected to a 230V A.C. supply. It is recommended that the power supply be protected by a residual current circuit breaker. (R.C.D.)
This fitting must be earthed.
This heat lamp is fitted with a switch to select either High or Low settings and can be used as an energy saving device or to reduce the level of heat on the animal. The switch can be operated without being disconnected from the supply.
Disconnect from supply. Unscrew lamp and replace. Screw into position. Reconnect to supply.
Suitable for use with infra-red lamps up to 250W max. Follow lamp manufacturers instructions.
Hard glass versions recommended for outdoor use or in areas of condensation.
The heatlamp must be kept clear of dust and dirt at all times, and during cleaning it must be disconnected from the supply.
Warning: Damaged appliances must not be used at any time.
BULB NOT INCLUDED